Test fit in car
Posted by Picasa
Check back for more self-serving prose, early & often
Tags
- bmw (34)
- car audio (34)
- diy (34)
- e46 (34)
- fiberglass (34)
- speaker enclosure (34)
Search This Blog
About Me
Twitter Updates
Blog Archive
-
▼
2005
(35)
-
▼
October
(34)
- If you look carefully, you can see an outline wh...
- Semi-final step. I ordered some trunk liner car...
- Mission accomplished. I have decent low end now w...
- Here's a shot of the trunk with everything mount...
- So here is an action shot of the amp & crossover m...
- Here is the board I am mounting the amplifier an...
- Here is the carpeted enclosure which blends into t...
- Sub is mounted. Time to hook up the amp. Note ...
- Lots of screws with lots of silicone on the insi...
- mounting mdf baffle board to mdf enclosure sides
- Yet another test fit ...(aka measure 90 times, dri...
- I was going to use some slick speaker terminals in...
- 8 guage power wire straight from battery w/ in lin...
- This is the enclosure bottom with liberal coveri...
- Test fit in carPosted by Picasa
- Adding some black silicone to ensure airtight seal...
- Another shot of baffle board clamped to table saw ...
- Cut hole for speaker in MDF baffle board. Then us...
- Added chopped matt and resin to mdf sides for seal...
- Added more resin and fiberglass via chop mat. Goo...
- Baffle board test fit onto mdf sides. The baffle ...
- Adding mdf to serve as perimeter side thingys so I...
- trimmed off excess glass from sides. At this poin...
- test fit (after some serious die-grinder action to...
- mold pulled from car (time for some rework)
- more fiberglass and resin w/ 4mm filler
- fiberglass and resin action
- some drop cloth action (which still did not preven...
- side supports
- still going with the duct tape
- duct tape - different angle
- duct tape start
- applying duct tape for the mold
- BMW 330xi spare tire/wheel well fiberglass install...
-
▼
October
(34)
No comments:
Post a Comment